For more information please contact:

Michael Heeg
Niagara-on-the-Lake Yacht Sales Ltd.
E-Mail: mike@niagarayachtsales.com

Nonsuchâ is a registered trademark of Mark Ellis Designs Ltd.

- not exactly as illustrated -

 

NONSUCHâ 33 STANDARD SPECIFICATIONS

 

Principal Dimensions

 

L.O.A.                                     33' 5"              (10.2m)

D.W.L.                                    31' 5.5"           (9.6m)

Beam                                      12'6"               (3.8m)

Draft                                       5'4"                 (1.6m)

Shallow Draft                         4'10"               (     m)

Displacement (approx)          15,350 lbs       (7,000 kg)

Ballast (approx)                     6,050 lbs         (2,750 kg)

Sail Area                                 669 sq ft          (62.2 sq m)

P=                                            50'6"

E=                                           26'6"

Mast above water                  58'9"

 

Hull & Deck

 

Single piece balsa cored molded FRP construction.

Balsa cored deck and hull.

Coring deleted in way of all fastenings and through hulls.

Anodized aluminum toe rail thru-bolted from deck to hull.

Teak and holly flooring.

Molded textured overhead liner with access panels to deck hardware fastenings.

External lead ballast bolted and bonded to re-enforced hull sump.

 

Colour and Paint Specifications

 

Molded colour (owners specification) cove and boot stripe

Standard hull and deck colour is white.

Optional colours available.

All exterior teak will be covered with teak oil.

 

Propulsion System

 

Yanmar 3JH4CE x SD 40-3 40 hrsp

Sail drive transmission.

Fresh water cooled (closed cooling)

Full instrumentation -Yanmar B panel and fuel gauge

Insulated engine compartment with light.

55 amp alternator.

Engine seawater strainer.

Racor fuel filter.

Sacrificial zinc anode on propeller shaft.

2 bladed fixed propeller.

 

Electrical System

 

Shore power outlet

2 batteries with provisions for a third battery.

Explosion proof battery switch.

12v accessory breaker panel.

Volt and amp meter.

Magnetic breakers.

110v breaker panel.

2 GFI 110v outlets (head and galley).

Regulation offshore running lights.

Brass swivel reading lamps.

Overhead dome lights.

Tinned wiring used throughout.

 

Plumbing

 

1 electric and 1 manual bilge pump.

Hot water heater - electric.

Hot and cold pressure water system.

Faucets in galley, head and shower.

Shower sumped into sink.

 

Tankage

 

1 integral fresh water tanks – 50 gallons (approx)

1 removable diesel fuel tank - 35 gallons (approx)

1 removable FRP holding tank - 33 gallons (approx)

 

Propane System

 

Propane solenoid shut off system.

Stainless steel 2 burner propane stove and oven.

1- 10 pound aluminum propane tank.

Enclosed and externally draining fuel locker.

 

Deck Hardware

 

Pedestal steering with brake and guard.

32" stainless steel destroyer wheel.

5" binnacle compass with light and cover.

40STC main halyard winch.

2  30STC control line winches.

44STC main sheet winch.

2 winch handles (one locking).

2 teak grab rails on deck.

Stainless steel grab rails at companionway.

Vinyl nosing around cabin house and cockpit.

Mooring cleats 8" and chocks 8" closed - forward, amidships and aft.

Vinyl coated upper and lower life lines - white.

2 large skylight hatches - Lewmar.

3 small skylight hatches - Lewmar.

2 large opening ports - Lewmar.

6 small opening ports - Lewmar.

2 large recessed deck drains and 2 cockpit scuppers.

Double rail bow and stern pulpit with boarding ladder.

All deck hardware is bolted through solid fiberglass with reinforcing overlays or backing plates.

 

Rigging System

 

White painted aluminum mast.

White painted aluminum wishbone boom.

Lightening grounded spar.

Colour coded low stretch lines and halyards.

Double reef system.

All control lines lead aft to cockpit.

Burgee halyard to masthead.

Vinyl coated hanging lines.

 

Cabinetry and Joinery

 

1 hanging lockers

Teak salon table.

Varnished teak and holly sole.

Varnished interior.

Teak drop boards.

Teak companionway ladder.

All locker inside painted off white gelcoat.

Locker doors to have space cut out bottom or top for vents.

 

Galley

 

U-shaped galley.

Large insulated ice box.

Dish and food storage aft and outboard.

Large dry locker in forward corner.

Double stainless steel sink.

Lid over refrigeration access with recessed hinges.

Sliders made out of teak.

Facings made out of teak.

Galley corner squared off to match liner.

 

Head and Shower

 

One piece molded FRP compartment.

Marine toilet with FRP holding tank.

Sink.

Storage below counter and outboard.

Separate shower stall.

 

Main Salon

 

Settee to starboard with electrical and navigation panels outboard.

Bookcase port side customer to choose shelf height.

Main salon table has rounded corners

Lockers on starboard are recessed with shelf behind backrest.

 

Forward Cabin

 

Large double berth 6'8" in length.

2 large drawers under aft end of berth.

2 lockers, bookshelves overhead and outboard.

Mast access door and hanging locker at foot of berth.

Hanging locker to starboard.

Access to the mast step and chain locker.

Bureau with drawers and lockers to starboard with mirrored door.

 

 

Quarter Cabin

 

Large double berth 6'6" in length.

Shelf overhead and outboard.

Open concept to main salon.

 

General

 

Emergency tiller

Fire extinguishers.

 

Specifications are subject to change at the builders’ direction.

 

 

The price for a standard Nonsuchâ 33 FOB Bowmanville is: $ 239,000.00

 

In Canadian funds.

 

 

Home | About Us | Maps | Storage | Repairs | Custom Build | Contact Us | Links

Wiggers Custom Yachts Ltd.

125 Port Darlington Rd.

Bowmanville, Ontario, L1C 3K3

TEL: (905) 623-5261

FAX: (905) 623-1402